Check out PIVOT KING

[ZIPGRAVER]

Any of you backyard fabricators that are planning on building a swing away tire carrier be sure to check out PIVOT KING, the SQUARE TUBE PIVOT...www.pivotking.com. For your prices just PM me or Dr Smash.

[litlmeck]

Do you have any installed pics?

[ZIPGRAVER]

Do you have any installed pics?

Not yet but soon

[Black's R&R]

I have to say I was a little "miffed" when I saw this after seeing that smash is a vendor...good on you for not trying to steal his gravy...

[ZIPGRAVER]

I have to say I was a little "miffed" when I saw this after seeing that smash is a vendor...good on you for not trying to steal his gravy...

What you don't realize is that Dr Smash doesn't MAKE anything like this. He buys them from outside vendors and then uses them on his great fabs. Besides PIVOT KING is intended for the amateur or home mechanic....something that Eric agrees with.

[Black's R&R]

What you don't realize is that Dr Smash doesn't MAKE anything like this. He buys them from outside vendors and then uses them on his great fabs. Besides PIVOT KING is intended for the amateur or home mechanic....something that Eric agrees with.

All I am saying is I thought I remembered seeing that eric is a vendor for theese as well(could be wrong) And I thought it was cool to see that you were share your little chunk of limelight on the site with this thread with smash...I know he doesnt make anything like this....btw what does one of theese cost? and are there different sizes?

[Black's R&R]

If Smash is not a vendor all previous satements are retracted (I may have been drinking last nite) I am still intrested in cost, etc

[ZIPGRAVER]

Eric is my exclusive distributor here. So yes he is da man! Just for information purposes go to the website www.pivotking.com and look at the prices then if you are interested we'll give you or anybody here a Reno 4X4 discount. The basic 2 bearing pivot sells retail for $60.00 which is less expensive than the round ones. Different models sell for different prices. I just think this is a great device because it is EASY and FOOLPROOF to work with. Clamp it, weld it and your done. No cutting or shaping or fitting. Remember this is DR SMASH APPROVED!

[Black's R&R]

Eric is my exclusive distributor here. So yes he is da man! Just for information purposes go to the website www.pivotking.com and look at the prices then if you are interested we'll give you or anybody here a Reno 4X4 discount. The basic 2 bearing pivot sells retail for $60.00 which is less expensive than the round ones. Different models sell for different prices. I just think this is a great device because it is EASY and FOOLPROOF to work with. Clamp it, weld it and your done. No cutting or shaping or fitting. Remember this is DR SMASH APPROVED!

ok thanks I will check them out